BREEDLOVEMOUNTS

          Heavy Duty Antenna Mounts for Mobile Ham Radios   $10 Flat rate Shipping  with Satisfaction Guaranteed !

The flat top ball mount with a
1-1/2 inch face to support a spring
or screwdriver antenna.
Model # 108    $94.95 

The ball is pinned to the top plate with two 1/4 inch delrin pins
    to prevent rotation of the antenna at highway speeds.

Quick disconnect ball mount with ring terminal connection. 3/8-24 top thread
Model #106    $105.00 

Extra centers and nuts available on the Accessories page.

And when you are ready to sell that vehicle but have a bunch of holes where your antenna was,  then you need a cap.    A   4-1/2 inch plate with the same bolt pattern  to cover up the mess and help hold the resell value. 

Also available with a slot for screwdriver control wire access from under the top plate on any of these packages.  Just click to add to your order.
ADD CONTROL WIRE SLOT  $15.00   Model #118

Model # 013   $45.00

Aluminum plates 3/8 inches thick and 4-1/2 inches in diameter

4 Stainless steel 5/16th bolts

Delrin insulators
1/8 inch thick rubber gasket
1/2-20 plated steel bolt with a 3/16th inch screw in the head for ring terminal connection
extra 3/16th inch screw on the back plate for the ground connection
the back plate is threaded so no nuts and washers needed

3/8-24 top thread for your antenna

The CB ball mount using a ring terminal connection for the signal. Model #110  $ 94.95

1 inch face with 3/8-24 thread in the top