BREEDLOVE MOUNTS

          Heavy Duty Antenna Mounts for Mobile Ham Radios   $10 Flat rate Shipping  with Satisfaction Guaranteed !

Description:   This mount fits all my brackets.  The nut that holds the antenna is recessed on the end to cap over the bottom part.  This eliminates  any chance of falling over.   It locks down tight and solid by hand, no tools required. One turn releases the nut to lay-over and if needed, just three more turns and you  remove the antenna completely. The nut stays attached to the antenna.  To use more than one antenna on the mount you can use extra nuts.  When laid over, the stud for the nut is against a dead stop at 90 degrees but there is no locking action when laid over.   The nut can be locked in place when laid over,  but not the swivel action. 
    But if you are wanting to travel with it laid down, then the solution is to just take it off,  or tie down the end of the whip so it can't bounce up and down.   If you tie it down, with the nut locked, the pressure from the weight on the swivel pin and stud  should ensure that you will still have a good connection if you want to keep transmitting..

The large nut is counter-sunk to cap over the top of the mount so it can't fall over even if it comes loose.

Fold over antenna mount with ring terminal connection.

Model  # 201   $ 40.00

3/8-24 thread in the top for the antenna
SO-239 cable connector in the bottom
1-1/4 inch delrin insulator
requires a 5/8 inch hole to mount
1 inch OD brass nut
1 inch Hex brass body
Stainless steel studs for the top available on the Accessories page.

3/8-24 thread in the top for the antenna
Ring terminal  connection in the bottom
1-1/4 inch delrin insulator
requires a 5/8 inch hole to mount
1 inch OD brass nut
1 inch Hex brass body
Stainless steel studs for the top available on the Accessories page.

Fold over antenna mount with SO-239 connection

Model  #202   $ 65.00